Best way to push plans and elevations to hololens

I would like to push some building plans and elevations at 1:1 scale to the hololens but thats a lot of curves… and it doesn’t seem to enjoy loading them all. Any advice for how to streamline this?
Thanks team folo!

Hey @kerbs my suggestion for all things AR is to only show the information you need, when and where you need it. You could try putting the linework on different layers and turning these on and off as required.

Another thing that comes to mind is you should check the detail in the curves and make sure that these are actually lines and not polylines consisting of thousands of segments - this could be streaming a tonne of data without you actually noticing any visible difference.

1 Like